SureBroom™ is the premier high-strength thin broom concrete overlay for extremely used trafficked areas. Its formulation is designed to transform old, spalling, broken concrete to a freshly broom surface as well as cracked resurfacing concrete. Typical areas requiring SureBroom concrete broom overlay include high rise parking decks, driveways, sidewalks, parking lots, and retail storefronts. Although designed to be broomed, it may also emulate the many designer looks of other thin overlays. SureBroom™ may be applied with a concrete broom or by a combination of compressed air spray equipment and trowel and or squeegeed. Restoration, repair, resurfacing, architectural accenting, surface protection, and creating slip resistance of existing concrete are all realized through SureBroom™. It is prepared with gray cement or white cement to accept Color Packs. SureBroom™ decorative overlay is the perfect product for restoring a "fresh" broomed concrete look to cracked or otherwise old slabs and substrates. This broom concrete overlay can be applied over very large surface areas including driveway concrete and concrete sidewalks resurfacing with ease utilizing a relatively small crew.
SureBroom can easily transform any surface in need of restoration:
1. Any surface receiving a cement-based coating must be clean, cured, sound and profiled. See our Surface Preparation products for more information on accomplishing this
2. Make sure that temperatures will remain between 50 and 90 degrees Fahrenheit and there will be no precipitation in the applied areas for a 48 hour period following application.
3. Add 4 - 6-1/2 quarts water per 50 lb bag to 5 gal bucket and mix in any color desired for the integral coloring of SureBroom concrete broom overlay.
4. Slowly introduce SureBroom while continuously mixing and mix for a minimum of 1 minute once all product has been emptied into the container. Scrape the sides of the bucket to make sure there are no "dry pockets" that didn't get mixed properly.
5. Mist the surface of the concrete with water ahead of any areas about to receive SureBroom.
6. SureBroom concrete broom overlay can be applied by trowel, squeegee or boom depending upon desired texture.
7. If you need a second coat of SureBroom concrete broom overlay, simply wait until the surface is properly cured - approx 2-6 hours. A second coat can be applied same as the first coat. Make sure to scrape away excess material from first coat before applying the finish.
8. Once the concrete broom overlay surface has dried and cured sufficiently (approx 2-6 hours), it can accept stains and secondary colorants, and is also ready to receive a sealer. Typical outdoor applications would utilize a acrylic sealer from our SureSeal line of products.
The premier, high strength, thin, broom finish concrete overlay for extreme high traffic areas, such as: parking lots, parking garages, ramps, stairwells, commuter stations and walkways. Designed to make old concrete look and perform like-new again, it transforms worn, spalling and weathered substrates into fresh, uniform and defect-free surfaces.
Don’t rip out old concrete; use this cost-saving alternative to restore your concrete, and make it look and feel brand new. While specifically designed for broomed finish concrete, it can also be used to replicate a variety of textures and designs.
Designed to resurface high traffic concrete without compromising color, design or texture. When properly applied and sealed, will produce an attractive, high compressive strength, highly durable surface with a long life-cycle and low maintenance requirements.
Make your concrete surface even stronger with this 6,100 PSI resurfacing overlay. It will also help provide slip resistance and proper coefficient of friction on outdoor surfaces that are subject to rain, ice or inclement conditions.